.. |ImAFM (TM)| unicode:: ImAFM U+2122


Hardware Connection images
==========================

.. _di-sam-label:

SAM III connections
'''''''''''''''''''

.. figure:: figures/breakout_box_1.jpg
   :width: 75 %
   :align: center
   
   Typical connections for the SAM from Veeco/Digital Instruments.  The images shows the SAM III, connected to a Dimension 3100 AFM.  These connections may be different, depending on the controller, AFM, and SAM versions.  The switches in the image are in the position for |ImAFM (TM)| (left for |ImAFM (TM)|, right for normal AFM).
   
 

.. _ns3-images-label:

Nanoscope III and IIIa Trigger Access
'''''''''''''''''''''''''''''''''''''

.. figure:: figures/nanoscope3_5.jpg
   :width: 75 %
   :align: center
   
   Remove the 4 screws in each corner of the lid on the NS-III or NS-IIIa controler.
   

.. figure:: figures/nanoscope3_2.jpg
   :width: 75 %
   :align: center
   
   Connect the End of Line (EOL) and End of Frame (EOF) triggers to the BNC connectors on the circuit board as shown.  The images shows  cables which bring the these connections to BNC bulk-head connectors mounted on the front panel of the controler.
   

.. figure:: figures/nanoscope3_3.jpg
   :width: 75 %
   :align: center
   
   BNC bulk-head connectors giving access to EOL and EOF connectors on the front panel.
   
   
..   _NS5-label:

Nanoscope V Connections
'''''''''''''''''''''''

.. figure:: figures/sam5_connections.png
   :width: 75 %
   :align: center
   
   The connections to the SAM-V from Bruker are identical to the SAM modules from DI and Veeco.  However, these SAM modules can not be used interchangably. 
   

.. figure:: figures/ns5_triggers.png
   :width: 75 %
   :align: center
   
   The EOL and EOF triggers are on the front of the NS-V controller.  Make the connections as labeled in the image.
   
   
   
.. _jpk-label:

JPK Nanowizard III Connections
''''''''''''''''''''''''''''''
   
.. figure:: figures/jpk_nw3_connections.png
   :width: 75 %
   :align: center