User Manual - Intermodulation AFM Software Suite

Contents:

• Introduction
  • Conventions and useful tips
  • Screen Layout
  • Python
• The IMP Session and Work Flow
  • Quick Start
  • Work Flow
    • Frequency Sweep
    • Calibration
      • Choose Cantilever and Method
      • Measure noise
      • Fitting noise data
      • Calibration Result
      • Current calibration
      • Add Edit Remove cantilevers
      • Calibrating torsional eigenmodes
    • Scanning
      • Setup and Scan
      • Measure just lifted
      • Set-point
      • Scan rate
      • Image settings
        • Color Bar
        • Image Toolbar
        • Mouse wheel zooming
      • Selecting Data in a Scan
        • Pixel inspector tool
        • Area inspector tool
        • Line inspector tool
        • Clear pixels tool
        • Level image tool
      • Status Banner
    • Analyze Scan Data
      • Image Smoothing
    • Session Overview
      • Session
      • Import host AFM data
      • Flip and swap scans
      • Batch process parameter maps and force volume data
      • Three dimensional viewer
    • Session Logbook
• Quantitative Analysis
  • Inspecting single pixels
    • Signal Inspector
    • Force Inspector
      • Dynamic force quadratures
      • Dissipated work and average potential
      • Reconstructed force
        • Force Reconstruction Methods
      • Force Inspector settings
      • Background force compensation
  • Analyzing lines and surfaces
    • Analyzing Linear Transects
    • Parameter Maps
  • Special Modes
    • Intermodulation Electrostatic Force Microscopy
      • Setting up the measurement
      • Analyzing and viewing the ImEFM data
• Advanced Topics
  • Intermodulation Measurement
    • Time mode
    • Frequency mode
    • Feedback
  • Noise Calibration
    • Note on sensitivity and accuracy
  • Programming your own Force Models
  • Data Tree
  • Advanced Setup
    • Frequency tuning
    • Setup Feedback
    • Measure
    • Units
    • Manual Setup
    • Out of Range Error
  • Drive Constructor
    • Configuring the MLA™
      • Pre-defined variables
      • Built-in functions
    • Synthesize and Configure
    • Setting the feedback
    • Debugging a script
    • Useful Python code blocks
  • Stream Recorder
    • Example script
  • Scripting Interface
    • RecorderAnalysis.py
    • LiveParampeterMap.py
  • ScanData
    • ScanData Class
  • File Management
    • File Types
  • Panels and Views
• Installation
  • Install Software
  • Install Hardware
    • Connection to computer
    • Connection to host AFM
  • Set AFM Type
    • Working without triggers
  • Common AFMs
    • Nanoscope ^TM III, IIIa, IV
    • Nanoscope ^TM V
      • software settings
    • Asylum MFP-3D ^TM
    • Asylum Cypher ^TM
    • JPK Nanowizard ^TM III
    • NanoTec Electronica
• Multifrequency Lockin Amplifier
  • Version III
  • Version II
  • Version I
    • Version I Firmware
• Trouble Shooting
• Changelog
• References